DJI M200 / M210 (RTK) - S1 / S2 / S3 homologation pack

The central module contains the system's dedicated electronics, the wireless communication module and a power supply battery independent of the drone's. It is composed of a red ignition button and an indicator LED. The central module also integrates the CO2 device consisting of a 16g threaded CO2 cartridge allowing the ejection of parachute canopies. A micro USB port is available to recharge the system's internal battery.The remote control module consists of a red adhesive base, an oval ignition button on the rear, a triangular motor cut-off button, an indicator LED, three white battery level LEDs, an extension port on the left side and a USB port on the right side for recharging.Each carbon ejector tube contains a parachute canopy and the ejection system for the canopy. A quick release system allows it to be fitted to either arm of the Matrix. They are connected by two flexible high pressure lines to the central module and must not be detached from it at any time during the operation of the system. The circuit breaker & alarm module, installed on the drone, contains the engine cut-off system in case of parachute activation and the 100 db audible alarm. It is connected to the central module by a flat cable and a red quick connector, this cable must not be disconnected once the parachute is installed.

S1 / S2 / S3 homologation documents include:

• type design certificate
• the certificate of conformity to type
• the use and maintenance manual

The assembly of the circuit breaker and the parachutes is carried out by us in our workshops located in Remiremont.

ATTENTION: the transport costs of your equipment are at your expense.